Whistler Hardwire Kit (206880)

Whistler Hardwire Kit Instructions

The power cable has a plug on one end which connects to the detector. At the other end of the power cable, the power and ground wires are separated. The ground wire has a “U” shaped connector which should be fastened to a metal surface. Look for an existing screw or bolt under the dash to use a grounding point. The power wire has a spade type connection which should be connected to a switched +12 volt DC circuit in your vehicle’s fuse box. A switched circuit is one that has power when your vehicles is on, but has no power when your vehicle is off. Connect the “U” type power to the ground point selected. Attach the power cord to the detector. Then touch the power wire to the +12 volt DC switched power source selected. If the detector sounds the self test sequence, then all connections are correct.